• 목록
• 답변
• 글쓰기
• 게시판 리스트 옵션
  • 수정
  • 삭제

Window Sash Repairs

Most homeowners don't pay attention to window sashes, so long as they are able to open and close and keep the air inside and the outside air out. But with time, they'll get worn out, causing air leaks, drafts, or even sashes sticking.

With a sash propped on a homemade easel and a glass, the artist creates secondary double glazing for sash windows points into gaps. He also scrapes off paint and applies a wood preservative on the frame.

Sash Weights

If windows aren't opening and closing smoothly or are sticking due to a problem with the counter-balancing system, it's possible that a may be to blame. This could be due to a missing or damaged chain/sash cord, an unattached or misaligned sash weight, or a broken pulley.

The sashweights are small, rounded boxes made of cast-iron that balance the counter-weight system and help support the sash. The sash weights are situated on the bottom rails of every window frame. They are covered by an unfinished wooden panel which can be removed to reveal their location. The panels can be removed to gain access to the weight pockets in the sash for cleaning, repairs or replacement.

If you've had sash windows for some time you likely have a problem with sash weights that cause them to sag or catch. The weights may be too heavy (they should be slightly heavier than top sash), or installed in a way that isn't correct.

To remedy this issue, remove the stops (the trim that runs along the inside edge of the window at the point that it joins the frame to hold it in place). Set them aside. This requires you to be gentle so as to not damage the appearance of your overlapping rails. Then, you can employ a hammer to break the stiles and rails and check them for damage.

After you've checked the rails and stiles, lay down dust sheets and then begin working on the sash itself. Start by taking the wood pegs out of the mortise and tenon joints using a pin punch and a hammer or screwdriver. Once the pegs are gone then you can begin to disassemble the sash by removing the stop moldings for sash, pulling off any sash cord knots still in place, and finally, removing the sash itself.

Next you will want to weigh the sash and determine how much weight is required for its proper operation. You can find old weights for sash replacement online or at a few home improvement stores, but be sure to purchase the right size to ensure not to under or over weigh the sash.

Sash Cords

The majority of sash and case window repairs window problems result from worn or broken sash cords. The weights put constant pressure on the sash cords, which can cause them to break over time. The sashes won't be able to open or close as easily if cords break. The issue could be caused by a variety of things like excessive force, aging, a lack of maintenance and moisture buildup. During window sash repairs, it's important to replace the old cords with new ones made from an material that lasts and resist moisture.

Begin by removing the interior stops which are the thin pieces of wood that keep the sashes in place using a utility knife and a chisel. Remove the stops from the sashes carefully, and keep an eye out for cracked or broken ones. After the stops have been removed, you will be able to access the sash weights via an access panel that is cut into the bottom of the frame or by opening the jamb and taking off the weight pocket cover.

Accessing the sash cords takes some effort however it's not too difficult with the right tools and patience. First, take off the old cords by cutting them close to their knots and pulling them free. Then, you can remove the sash from the frame and put it aside. When the sash is removed and you have pulled it down, grab the staff bead (the nail that keeps the sash from falling) and then insert one nail that is about 1 foot into the hole for the staff bead. This will hold the sash on its place while you string counterweights.

After reinstalling the upper sash, reattach the sash cords and ensure that the sashes are properly balanced and move smoothly. Then, install the lower sash, and repeat the process, ensuring that the sashes are properly seated and moving smoothly.

After you've finished installing the counterweights, reattach the sash cords, by inserting a sash cord through the pulleys and then threading the other end of the cord through a knot hole inside the sash to secure it in the correct position. Repeat the procedure for each side of the sash until all the cords are replaced and the sashes function normally.

Air and drafts Leaks

As time passes, the materials that secure sash windows to your frame of your home deteriorate, resulting in drafts and loss of energy. A thorough inspection will identify the areas of concern and assist you in determining your window sash repairs options. Your preferences regarding comfort and experience level determine whether you are able to handle window repair or require expert input. The scope of work required is also influenced by historic status of the property and its structural integrity.

If cold air enters through a sluggish window, your furnace must work overtime to keep your home warm. This inefficiency can eat into your heating bills and compromises the efficiency of your home's HVAC system. Moreover, drafts disrupt your indoor comfort and degrade the quality of your indoor air by bringing the infiltration of outdoor pollutants, allergens and humidity.

A typical sign of a drafty windows is the feeling of cold air in your room despite all doors and windows being closed. Other signs to be aware of are a change in temperature near the window, and condensation on the sill or frame.

Fortunately, fixing drafty windows is a simple job that can lower your energy bills and improve indoor comfort. First, look at the outside of the window. Check for wood that isn't bare and areas where the old caulking has cracked, opening the gaps to cold air.

Examine the interface of the sash with the frame. This includes the parting beads, and the staff bead. Examine the condition of the weather stripping (felt strips or foam tape) at these locations to determine if they are intact and effective. If not, this needs to be replaced.

Then, think about the condition of secondary glazing sash window putty. It is a hard putty that keeps panes of glass in place. Examine for cracks and crumbling that can expose the sash's exterior to moisture. This can cause mold issues and damage to the glass.

Apply a new layer of glazing putty to the inside of the window to correct the problem. Using a flat-blade screwdriver, push the glazing points into position to secure them. Then wrap a piece of foam and a fabric around each point to create an insulation lawyer against cold air.

Aesthetics

Window sash repairs can give old windows a fresh new look with less expense than a complete window replacement. Particularly for those who have older homes, a full replacement could be a huge project, and a substantial financial commitment. Repairing window sashes can be an excellent way to bring back a home's original beauty and value.

Keeping a close eye on the condition of your window sashes is crucial to avoid major problems. It is best to consult an expert if unsure if your windows need repair. A sash repair can be much cheaper than replacing the entire window and can also save you money on energy costs.

The first step is to lower the upper sash down to the bottom. This is usually simple and will give you a clear view of the "parting beads" (these are the grooved bits in the meeting rail on either side that keep the two sliding sashes apart). They can be removed by the help of a small pry-bar or a putty-knife. They are typically nailed into place and painted, so you need to be careful not to harm them or the sliding sash.

After you have removed the parting beads, you'll need to take off the pocket covers. These are small pieces of wood that are screwed into the frame at the bottom. They allow access to the sashweights. After the nails are removed then you can move the sash upwards and downwards in order to make sure it moves easily.

If it doesn't then there may be an issue with the counterweights and sash cords. Once you've checked all of these, you can repair them if needed.

Wooden windows look beautiful and natural. They work well with modern or traditional interiors. They are also highly customizable with a variety of stain and paint options. However, wooden sash windows cost windows require regular maintenance to avoid damage and rot.